Our investment has been a huge increase in production. I would say 4-5 times from our previous manual methods.

What we've found is that even with the time zone difference, we have never had a problem getting an answer from Peddinghaus service.

When we saw the latest machine from Peddinghaus could process thicker plate and could drill smaller holes, we knew we needed that additional capacity.

We hand over the keys to the building when the project is finished.

Before we started using the machine, we did approximately 80 columns per week. After the Advantage-2, we went up to 500 columns per week.

We've been thrilled about the compatibility of Peddinghaus' machinery with our downloads that come out of our 3D modeling software.

Clearly the success that we’ve had on projects is heavily dependent on the Peddinghaus equipment accuracy, reliability and efficiency.

Some columns we have, it has taken a fitter 6-8 hours to fit it. Now with the PeddiAssembler, we're probably fitting that in maybe 30 or 45 minutes.